FPV Drone Flight Time & Efficiency Calculator
Flight time, hover current, thrust-to-weight and heat for the motor, prop and battery you pick.Results
Your parts
?
KV is how many RPM the motor adds per volt, with no load. 1750KV on a full 6S pack (25.2 V) ≈ 44,000 RPM. High KV suits small props and low voltage, low KV suits big props and high voltage. 2207 = a stator 22 mm wide and 7 mm tall.
?
Diameter is the prop's size in inches (5 in ≈ 12.7 cm). Pitch is how many inches the prop would "screw" forward through the air in one turn, like a bolt. 5×4.3×3 = 5 in diameter, 4.3 pitch, three blades. More pitch means more speed, but also more current and heat.
?
S is the cell count: each cell is 3.7 V (4.2 V full), so 6S ≈ 22.2 V. mAh is the capacity, the "size of the tank". C says how fast current can be drawn: 1300 mAh × 95C ≈ 123 A on paper.
?
Takes commands from the flight controller and drives current into each motor, thousands of times a second. A 4in1 has four ESCs on one board. The amp rating is the continuous current each channel can handle, and it needs headroom above the motor's peak draw.
?
A gyro, a processor and firmware (Betaflight / INAV) that stabilise the drone thousands of times a second. The arrow on the board marks the forward direction. In the calculator it only affects weight.
?
A camera and transmitter that send the picture to your goggles. Analog is light and cheap. Digital (DJI, Walksnail, HDZero) gives a sharper picture but is usually heavier.
?
Gets the commands from your radio — e.g. ELRS or Crossfire — and passes them to the flight controller. Very light, but every gram counts.
?
Gives position, speed and Return to Home. Important for long range and flights over open ground.
?
The arms and plates everything mounts on. You choose it by prop size. It's usually the heaviest part after the battery.
All numbers are computed from transparent physics formulas (momentum theory) based on the components' manufacturer specs. Results are marked as estimates — not measurements. Full details below.
How it's calculated — the formulas and assumptions
- Hover: momentum theory. Hover power
P = T^1.5 / √(2ρA) / η, where T = weight in newtons, A = total disc area of all props, ρ = 1.225 kg/m³. η = whole-system efficiency (prop figure of merit × motor and ESC electrical efficiency) ≈ 0.25 in hover — calibrated against a real bench build (6" props, 6S, ~1 kg all-up weight, ~13 A measured hover current); small FPV props are simply not very efficient. So P is the electrical power, and the current follows from it. This is the assumption that affects flight time most. - Hover time:
(capacity × 0.8) / hover current. The 0.8 = safe usable fraction (don't drain below ~3.5V/cell). "Mixed flying" ≈ 60% of hover time (a rough estimate, depends on style). - Max thrust: the lower of two — what the supply can feed (
V × min(motors × ESC, C × capacity), at a full-throttle efficiency of η ≈ 0.45) and what the prop can actually produce (a ceiling by diameter, calibrated to real builds + MQTB bench measurements). That ceiling stops a big ESC/battery from "inflating" imaginary thrust on a small prop. Peak current is derived from the thrust actually reachable — not from the ESC rating. Thrust-to-weight = max thrust ÷ weight. - RPM and prop tip:
RPM ≈ KV × full voltage × 0.65(loaded, full throttle); tip speed = circumference × RPM; Mach = tip ÷ 343. - Pitch: pure momentum theory sees only disc area, not pitch, so pitch enters as a load factor: hover power is multiplied by
1 + 0.55 × (P/D − 0.6)— neutral at a pitch-to-diameter ratio of 0.6 (a typical freestyle prop), higher for aggressive pitch, and at most 20% lower for very low pitch. High pitch costs some flight time and adds heat; its real benefit (top speed) is not modelled here. - Weight estimate: the sum of manufacturer weights for every part you picked — motors, props, ESC, FC, video system, receiver, GPS — + battery (≈6.6 g per Wh) + frame (separate field, default by prop size, plus 8% of the frame weight for wiring, screws and straps). It's an estimate; uncheck "Compute automatically" and enter the exact weight you measured on a scale.
- Heat index (0–100): a rough indicator, not a temperature. It combines how hard the motors work to hover (hover thrust as a share of max thrust), prop-tip Mach at full throttle (a fast tip means a lot of aerodynamic power and heat — this is what flags a high-KV motor on too many cells, e.g. a 4S motor on 6S), and aggressive pitch. Under 40 = cool, 40–70 = warm, over 70 = hot. Real temperatures come from a flight log and a touch test after landing.
- Component specs (KV, ESC rating, C, diameter) come from manufacturer data. Where a spec is missing, the value is flagged and computed from a default.
Pick a motor, propeller, battery and ESC, and the calculator instantly shows how long the quad will hover, how much current it draws in hover, its thrust-to-weight ratio, how hot the motors will run and whether the parts fit together. Choose from hundreds of parts with manufacturer specs, or type in your own numbers.
How to calculate FPV drone flight time
Flight time in minutes is roughly the battery's usable capacity divided by the average current, times 60. Usable capacity is about 80% of the label capacity, because you never drain a LiPo to empty.
Example: a 6S 1300 mAh pack gives about 1.04 Ah of usable capacity. A quad that hovers at 12 A will hover for about 5 minutes, and if it averages 20 A in flight, about 3 minutes. The real question is how much current the quad draws — and that's what the calculator works out, from the weight and the prop size, using momentum theory.
Thrust-to-weight ratio: how much does an FPV drone need?
Thrust-to-weight is the combined maximum thrust of all the motors divided by the drone's weight. It decides how lively the quad is: how fast it accelerates, climbs and recovers from a move.
| Ratio | What it means | Good for |
|---|---|---|
| Below 2.5:1 | Weak — very little spare power | Not suitable for aggressive flying |
| 2.5:1 to 4:1 | Calm and efficient | Long range, cinematic, cruising |
| 4:1 to 9:1 | Strong and healthy | Freestyle and racing |
| Above 10:1 | Very strong, can be twitchy at low throttle | Racing — usually with a throttle limit |
Typical flight times by drone size
These are common ranges for normal flying. Weight, flying style and weather move them up or down — the calculator gives you the number for your own build.
| Drone | Common battery | Typical flight time |
|---|---|---|
| 65–75 mm whoop | 1S, 300–550 mAh | 3–5 minutes |
| 3-inch | 4S, 650–850 mAh | 4–6 minutes |
| 5-inch freestyle | 6S, 1050–1300 mAh | 3–5 minutes (calm: up to ~7) |
| 7-inch long range | 6S LiPo 1800–2200 / Li-ion | 8–12 minutes on LiPo, 15+ on Li-ion |
| 10-inch | 6S LiPo 5000 / Li-ion 6S2P | 15–30 minutes cruising |
Estimated ranges for normal flying, not a guarantee.
What affects flight time
- Weight — the strongest factor: hover power rises roughly with weight to the power of 1.5, so 10% more weight means about 15% more current.
- Prop size — a big prop moves a lot of air slowly, which is more efficient. That's why a 7-inch flies longer than a 5-inch.
- Pitch — more pitch adds speed, but also load and current.
- Battery type — Li-ion stores more energy per gram and suits cruising; LiPo delivers more current for freestyle.
- Flying style, wind and cold — freestyle with lots of full throttle draws several times more than calm cruising.
How to use the calculator
- Pick a motor, prop, battery and ESC from the lists — every list holds real parts with manufacturer specs.
- Add the video system, receiver, GPS and frame — they all count toward the weight.
- Read the four gauges: flight time, thrust-to-weight, ESC load and motor heat. Green = fine, orange = keep an eye on it, red = fix it.
- Swap the battery or prop and see straight away what improves and what gets worse.
- Part not on the list? Tick "Show numbers" and type in the KV, diameter, pitch, cells and capacity.
How it works
- Hover power comes from momentum theory: the power needed to hold the quad's weight in the air for the disc area of its props. The whole-system efficiency factor is calibrated against a real, measured build.
- Hover time = 80% of battery capacity divided by hover current (you don't drain a LiPo to empty). Mixed flying is estimated at about 60% of hover time.
- Max thrust is the lower of what the battery and ESC can supply and what the prop can actually produce — so a big ESC on a small prop can't "inflate" imaginary thrust.
- Weight is summed automatically from the manufacturer weights of the parts you pick, plus the battery and frame. If you've weighed your quad, enter the real number.
What it doesn't know
- It's an estimate, not a measurement. Flying style, wind, temperature, battery age and tune all change the real result.
- The heat index is a relative indicator, not a temperature in degrees. After the first flight, touch-check the motors.
- Top speed, drag and aggressive flying aren't modelled. For the exact number, use a Blackbox log from a real flight.
FAQ
How long does an FPV drone fly?
A 5-inch freestyle quad on a 6S 1050–1300 mAh pack usually flies 3 to 5 minutes. A 7-inch long-range quad on Li-ion can cruise for a quarter of an hour or more, and small whoops fly 3–5 minutes. The calculator estimates it for your specific build from its parts.
How accurate is the flight time estimate?
The hover model is calibrated against a real, measured build, so for a typical quad in calm hover it should land in the right range — but it's an estimate, not a measurement. Freestyle and racing pull much more average current, which is why there's also a "mixed flying" figure (about 60% of hover time). The real number comes from a measurement: a timer on your first flight or a Blackbox log.
What thrust-to-weight ratio does an FPV drone need?
For freestyle and racing, roughly 4:1 to 9:1 is healthy. Below 2.5:1 the quad is weak and unsafe to fly hard; above 10:1 it can feel twitchy at low throttle. Long-range and cinematic builds can run lower in exchange for flight time.
Why doesn't a bigger battery always add flight time?
Because a bigger battery is also heavier, and hover power grows faster than weight (to the power of 1.5). Past a certain point every extra mAh is eaten by the weight it adds. The calculator shows this right away — try swapping batteries.
Does it work for tiny whoops and big lifting drones?
Yes — the lists cover motors, props and batteries from 1S whoops up to 10" and 15" props. Accuracy is lower at the extremes, since the calibration was done mostly on 5–7 inch quads.
What is motor KV and how does it matter?
KV is how many RPM the motor adds per volt, with no load. A 1750KV motor on a full 6S pack (25.2 V) spins about 44,000 RPM unloaded. High KV suits small props and low voltage; low KV suits big props and high voltage.
How do I know if my ESC is strong enough?
Compare each ESC channel's continuous current with the motor's peak current. The calculator shows the peak current per motor and the ESC load as a percentage, and warns when there isn't enough headroom.
Is the calculator free?
Yes. It's completely free, with no sign-up, and works in the browser on desktop and mobile, in English and Hebrew.