TBS Crossfire Nano RX Pro
The TBS Crossfire Nano RX Pro is a version of the standard Nano receiver with much higher telemetry power. Crossfire became the long-range control standard, running at 868/915MHz, which penetrates better than 2.4GHz and holds a link over long distances. What the Pro changes is the downlink: it sends telemetry at up to 500mW, compared with 40mW on the regular Nano RX, and the power is selectable - 25, 100 or 500mW. That keeps telemetry (battery voltage, RSSI, GPS) reaching your radio on far-out flights. The receiver weighs half a gram and measures 11 x 18mm, with the same size and pinout as the regular Nano, so it is a direct swap. It takes 3.3-8.4V with reverse-polarity protection, and the antenna connector is U.fl. Connect it to the flight controller over CRSF on a UART; the pins can also be set to SBUS, PWM or MAVLink. Crossfire firmware 6.14 or later is required.
Features
- Telemetry up to 500mW (25 / 100 / 500mW selectable)
- 868/915MHz long-range link
- Tiny: 11 x 18mm, 0.5g
- Same size and pinout as the regular Nano RX
- CRSF to the flight controller; also SBUS, PWM or MAVLink
- 3.3-8.4V input, reverse-polarity protected
- U.fl antenna connector, firmware 6.14 or later
Specifications
In the box
- 1x Nano RX Pro receiver




