Hobbywing XRotor 100A 4-in-1 ESC 8S Lite AT
A 4-in-1 ESC from Hobbywing's XRotor Lite line for 4S to 8S packs. It handles 100A continuous and 120A peak per channel. Hobbywing aim it at four-motor FPV drones of 15 to 18 inches, such as heavy-lift and long-range builds. It runs Hobbywing's own 32-bit firmware on an F421 MCU and can also be moved to AM32. It supports PWM and DShot300/600, bidirectional DShot for RPM filtering, and motor direction setting. The drive frequency is 48kHz, and settings are changed through BLHeliSuite. The board has a TVS diode to clamp voltage spikes, copper heat bars and damping grommets at the mounting points, and a low-ESR capacitor comes in the box. It measures 60x57x7mm and weighs 38.3g. Tips: the motor outputs are bare solder pads with no wires. The input leads are 8AWG with no connector, so you need to solder on a connector rated for the current. Solder the capacitor close to the input pads. Before you plug in the 8-pin SH1.0 cable to the flight controller, check that the pin order matches at both ends.
Features
- 100A continuous, 120A peak per channel
- 4S to 8S
- Hobbywing 32-bit firmware, AM32 compatible
- DShot300/600, bidirectional DShot and RPM filtering
- TVS diode, copper heat bars and damping grommets
- Low-ESR capacitor included
- Built for 15-18 inch drones
Specifications
In the box
- ESC with 8AWG input leads (red and black, 135mm)
- Low-ESR capacitor




