Herelink vs SIYI vs Skydroid: Long-Range Drone Video Links
Mapping, inspection and payload drones need more than a picture in a pair of goggles. They need steady video from a gimbal camera, a reliable control link and telemetry to a ground station, often over several kilometres. Integrated digital links such as CubePilot Herelink, SIYI and Skydroid carry all three in one radio, and choosing between them comes down to range, latency, the video source and your autopilot.
One radio for video, control and telemetry
A traditional setup uses three separate radios: an RC link, a telemetry radio and a video transmitter, each with its own antennas and its own band. An integrated system replaces them with one air unit on the aircraft and one ground unit, usually a handheld controller with sticks and a built-in Android screen. The air unit outputs S.Bus to the flight controller, passes MAVLink telemetry over a serial port, and sends the camera's video back to the screen.
Fewer radios mean less wiring, fewer antennas to place and less self-interference, and the operator sees video, the map and telemetry on one screen. The price is a single point of failure: if the link drops, control, video and telemetry go together. Set the autopilot's failsafe, such as return to launch (RTL), before the first flight.
The main systems at a glance
These are the makers' own figures, and they describe ideal conditions:
- CubePilot Herelink: 2.4 GHz, stated range up to 20 km in FCC mode and 12 km in CE mode, about 110 ms video latency, 1080p. The air unit takes two Micro-HDMI video inputs and has two S.Bus outputs (control and gimbal) and a telemetry UART; V1.1 adds an Ethernet port. The controller runs QGroundControl and Solex TX, and the system is designed for Cube autopilots running ArduPilot or PX4.
- SIYI handheld ground stations (MK15, UniRC 7): a controller with a screen, and an air unit with S.Bus, PWM, serial and Ethernet ports. Video comes over Ethernet from IP cameras and SIYI gimbals. Depending on the model the link uses 2.4 GHz, 5.8 GHz or both: the UniRC 7 Pro is dual-band, while the standard UniRC 7 is 2.4 GHz only.
- SIYI HM30: the same kind of link without a built-in controller screen. The ground unit takes RC from your own radio over S.Bus or PPM and passes video and telemetry to a tablet or laptop.
- Skydroid H16 and H12: 2.4 GHz FHSS systems with an Android controller, a receiver with S.Bus output and serial telemetry ports, and 1080p digital video, usually from a Skydroid camera. Range depends on the version; the standard H16 is stated at 10 km.
Range, latency and picture quality
Stated ranges assume clear line of sight, height above the ground and little interference. SIYI's own specification shows how wide the spread is: the same system is rated at 30 to 40 km over the sea at 150 m altitude, 10 to 15 km over rural terrain at 120 m, and 3 to 6 km for spraying drones flying at 3 to 6 m. Plan missions on the realistic figure for your terrain and height, not the headline number.
Latency in these systems is typically 100 to 200 ms. That is enough to fly a mission, frame a shot or inspect a structure, but it is clearly slower than the few tens of milliseconds of FPV video. Resolution and bitrate trade off against range: near the edge of the link most systems lower the bitrate or the channel bandwidth to keep the picture alive, so the image gets softer before it drops.
2.4 or 5.8 GHz, and what the rules allow
For the same power, 2.4 GHz travels further and copes better with partial obstruction, while 5.8 GHz offers more channels and less congestion but shorter range and less tolerance of obstacles. Dual-band systems can move to whichever band is cleaner. Avoid flying a separate 2.4 GHz RC or telemetry radio next to a 2.4 GHz video link, as the two will interfere with each other.
Radio rules are local. Many of these systems offer an FCC mode with higher transmit power and a CE mode with lower power, and the mode you may use is set by the rules where you fly, not by which one reaches further. In Israel, wireless equipment and the use of radio frequencies are regulated by the Ministry of Communications, which decides which bands may be used without a licence and at what transmit power, including antenna gain. Equipment imported into Israel also needs the ministry's approval for the specific model. Check the current rules on the ministry's website before buying or flying; the flight itself is regulated separately by the Civil Aviation Authority.
Antennas and where to mount the air unit
Most range problems are antenna problems. Mount the air unit's antennas vertically, below the airframe where possible, with a clear view of the ground station in every attitude, and keep them away from carbon fibre, batteries and metal, which block and detune the signal. Keep them away from the GNSS receiver as well: a strong transmitter close to the GPS antenna can degrade satellite reception.
On the ground, an omnidirectional antenna radiates most strongly from its sides, not its tip, so turn the side towards the aircraft rather than pointing the tip at it. Directional antennas add range but must be aimed, which a tracker or a second operator can handle on long missions. Replace damaged antennas and extension cables with parts made for the right band; an antenna for the wrong band can cost most of the range.
Cameras and gimbals
Check how video gets into the air unit. Herelink takes HDMI, so it suits any camera or gimbal with an HDMI output. SIYI's systems are built around Ethernet: an IP camera or gimbal such as the SIYI A8 mini streams over the network, and an HDMI camera needs a converter. Skydroid kits usually come with a matching camera, so check which video inputs the receiver accepts before planning a different one.
Gimbal control can come from spare channels on the ground station's sticks, wheels and buttons, or from the autopilot, which lets the flight controller point the camera during a mission. ArduPilot supports several gimbal brands directly, including SIYI, and many gimbals also accept the MAVLink gimbal protocol used by PX4. For zoom or thermal payloads, check the bandwidth too: two video streams, or 4K, need more of the link than a single 1080p feed.
Autopilots and ground station software
These systems pass standard MAVLink, so they work with ArduPilot and PX4 flight controllers. The controller's Android screen can run QGroundControl, and Herelink also comes with Solex TX. Most systems can also forward telemetry to a laptop running Mission Planner or QGroundControl, over Wi-Fi, USB or Ethernet depending on the model.
Wire the air unit's S.Bus output to the flight controller's RC input, and its telemetry port to a free serial port set for MAVLink at the baud rate the link expects. Power the air unit from a clean BEC within its input voltage range, and update both ends to the latest firmware before the first flight: pairing and firmware mismatches are the most common setup problems.
When DJI O4, Walksnail and other FPV systems fit better
FPV digital systems are built for flying through goggles: latency of a few tens of milliseconds, light air units and cameras, and image processing tuned for fast flight. They carry video and an OSD from the flight controller, while control goes through a separate radio link such as ELRS. For freestyle, racing, cinematic FPV and long-range FPV wings they remain the right choice.
An integrated ground-station link makes more sense when someone other than the pilot needs the picture, when the camera sits on a gimbal, when the aircraft flies autonomous missions from a ground station, or when one rugged controller with a screen works better in the field than goggles. Some operators combine the two: an FPV system for the pilot and an integrated link for the payload.
Checklist before you buy
- Realistic range for your terrain and flying height, not the headline figure
- A band and transmit power allowed where you will fly
- A video input that matches your camera: HDMI, Ethernet or the system's own camera
- Enough channels for flight modes, gimbal and payload, plus MAVLink telemetry to your autopilot
- Air unit input voltage, weight and size that suit your airframe
- The ground station app you want, on the controller or on a laptop
- Failsafe set and tested on the ground before the first flight



